Editing Autocal™ Settings Manually - Genelec SE Operating Manual

When the calibration process is running, a test tone is switched on by the GLM.SE™, and the microphone
signal is recorded and analyzed. All noise or other audio signals should be avoided during the calibration
process, while the test tone is playing.
Editing AutoCal™ Settings Manually
Once AutoCal™ measurements have been taken, they become available in the GLM.SE™ Acoustic
Editor. A new button will appear under the graphic presentation of the equalizer response.
Clicking the "Interactive Response Editor" button opens a new window, the Interactive Response Editor.
This window now shows the response measured by AutoCal™, the correction and the corrected acoustic
response. This view is interactive and will immediately respond to changes in the controls on the Acoustical
Settings Editor page. Manually editing the numbers in the Room Response Controls section on this page
will change the correction in the loudspeaker. The same can be affected by pulling any controls on the
61