Table of Contents
Advertisement
Menu Items
The "File" menu allows access to System Setup files.
•
"File | New" Starts the System Setup Wizard and is used to make a new setup from the
beginning.
•
"File | Open" Loading a System Setup File in the GLM.SE™ automatically sets up all loudspeakers
in the system with monitoring group definitions, audio cable definitions, defaults for monitoring
levels and all acoustical alignment settings from a previously saved System Setup File.
•
"File | Save" stores all settings into the currently open System Setup file.
•
"File | Save As..." is used to save modifications in the current setup under a new System Setup
file name.
•
Up to five recently used System Setup files are listed below "Save As".
•
"File | Exit" closes the GLM.SE™.
•
"Setup | Set GLM.SE™ Startup Level" reads and stores the current setting of the volume fader
and uses this volume setting when starting the GLM.SE™.
•
"Setup | Calibrate Reference Level" opens the Reference Level Calibration page.
•
"Setup | Configure Powermate Controls" opens the Powermate configuration page.
•
"Setup | Change Channel Order" allows for changes to be made to the order in which audio
channels are listed in the Groups.
•
"Setup | Password Protection" allows for password protection of System Setup files. After setting
a password, a System Setup file can be opened but not saved without knowing the password.
This way, System Setups can be protected from unwanted tampering or alteration.
•
"Setup | Acoustical Setup Wizard" runs the Acoustical Setup Wizard for with the currently open
System Setup file. To create a new setup from scratch, select "File | New" and then run the
Rapid or Manual Cabling Wizard and Acoustical Setup Wizard.
68
Advertisement
Table of Contents
