Table of Contents
Advertisement
Then place the mouse cursor on the blue Q-value icon, press down the left mouse button and drag to adjust
the Q-value to 5. The Q-value to be adjusted now depends on which notch filter was selected. To adjust the
Q-value of a specific filter, click on one of the notch filter triangle icons or click on the selection button in the
parameter table.
Interactive Response Editor
If an AutoCal™ measurement (SinglePoint or MultiPoint) of the loudspeaker has been taken, the
"Interactive Response Editor" button is visible. When clicked, the "Interactive Response Editor" window is
displayed. It displays the in-room response measured by AutoCal™ and shows how the current Acoustical
Settings modify the response.
The Acoustical Settings (Room Response Controls and Level) can be changed interactively in order to
see the effect on the measured response. This facility allows for inspection of the effect of the current
Acoustical Settings and may be used after running AutoCal™ to make controlled adjustments to the
parameters. The 0 dB level in the acoustic response plot is the reference level set by AutoCal™ and is
consistent across all loudspeakers and subwoofers in a system. Any changes to the controls mentioned
above will change the filtered response curve relative to the 0 dB level.
79
Advertisement
Table of Contents
