Table of Contents
Advertisement
Genelec Loudspeaker Manager (GLM) 4 - System Operating Manual
page 24 of 87
4.4 Downloading and Installing GLM Software
The GLM software calibrates and controls Genelec SAM systems. The software can be
downloaded at www.genelec.com/glm.
Look for 'GLM 4 install package'.
In order to download, you will be asked to give your email address and some contact information.
This is very useful as it enables Genelec to support you later. It is not possible to download the
package without a valid email address. You will receive a download link into your personal email.
You must have sufficient rights to install the software in your computer. Install the software
following the instruction given by the software during the installation process. We recommend you
install the software on the local hard drive. There is no need to make any special destination
folders, GLM creates these automatically.
Figure 13. GLM software download
GLM requires an Internet connection. The Internet connection is used for the GLM AutoCal
calculations in the Genelec Cloud. GLM AutoCal has been continually improving since its
introduction 2006 and using the Genelec Cloud service ensures you have always access to the
newest, most up-to-date algorithms and tools for calibrating your audio reproduction system.
Genelec Cloud is the default set in the GLM software, Genelec recommends using the Genelec
Cloud for AutoCal as this offers the most accurate calibration.
4.5 Downloading and Installing the local AutoCal calibration
If you are running a computer that never has an Internet connection, it is possible to install a local
calculation needed for GLM AutoCal system calibration. This should be avoided if possible as the
local calibration does not develop and improve automatically as does the standard Genelec Cloud
based GLM AutoCal calibration.
GLM must installed before installing the local AutoCal. The local AutoCal package does not work
without GLM.
Advertisement
Table of Contents
