Table of Contents
Advertisement
Step-By-Step System Setup for GLM.SE™ Control Network Use
The Genelec GLM.SE™ DSP System uses a networking concept for controlling a multi-channel system.
A control network cable is provided with all Genelec GLM.SE™ systems.
To setup quickly, follow the steps detailed below. For further information consult the sections of this manual
mentioned in each step.
•
Unpack and position the loudspeakers. See the "Loudspeaker Placement" section for details.
•
Find the Genelec Control Network cables in the SE7261A delivery box. Connect the control
network. See the "Genelec control network cabling" section for details.
•
Find the Network Interface and follow cabling instructions. See the "GLM.SE™
Network Interface Device" section for details.
•
Label and connect the audio cables. See the "Audio Cabling" section for details.
•
Launch GLM.SE™, then follow the on-screen instructions to complete a System Setup. Select
either Rapid Cabling Mode or Manual Cabling Mode and follow the instructions.
•
Select the appropriate Rapid Cabling preset in the GLM.SE™ and launch the Rapid Cabling
Wizard. See the "Rapid Audio Cabling" section for details.
•
To acoustically align the system, run the Acoustic Setup Wizard in the GLM.SE™. See the
"Acoustic Setup Wizard" section for details.
•
Congratulations! Setup is now complete!
A more detailed system setup procedure can be found in the section describing the System Setup
Wizard.
Step-By-Step System Setup for Stand-Alone Use
Stand-Alone Use
Genelec DSP loudspeakers can be used like any other loudspeaker system, without the GLM.SE™
control network. This is known as stand-alone use.
•
Note that when a 8130A loudspeaker detects a valid AES/EBU word clock, the system will
sync and run in the digital input mode.
•
DSP subwoofers only have digital audio inputs and can be used in stand-alone mode running
AES/EBU-digital audio.
•
For more information on setting up and using loudspeakers in stand-alone mode, see the
section on stand-alone operation.
25
Advertisement
Table of Contents
