Table of Contents
Advertisement
Copy the firmware file onto the root directory of your USB memory device.
3. Insert the USB memory device into the front-panel USB port on your
instrument.
4. Push the Utility button, select Function in the right menu, select Update in the
left menu.
5. In the right menu, select Start, the messages below will be shown.
In the right menu, select Start again, the interfaces below will be displayed in
6.
sequence. The update process will take up to three minutes. After completion,
the instrument will be shut down automatically.
Press the
7.
How to Measure Automatically
Push the Measure button to display the menu for the settings of the Automatic
Measurements. At most 8 types of measurements could be displayed on the
bottom left of the screen.
The oscilloscopes provide 39 parameters for auto measurement, including
Period, Frequency, Mean, PK-PK, RMS, Max, Min, Top, Base, Amplitude,
Overshoot, Preshoot, Rise Time, Fall Time, +PulseWidth, -PulseWidth, +Duty
Cycle, -Duty Cycle, FRR, FRF, FFR, FFF, LRR, LRF, LFR, LFF, Delay A→B ,
Delay A→B , Cycle RMS, Cursor RMS, Screen Duty, Phase A→B , Phase
4.Advanced User Guidebook
button to power on the instrument.
38
Advertisement
Table of Contents
