Changing The Current Scsi Ids - HP Surestore 160ex - Optical Jukebox User Manual

Changing the Current SCSI IDs

READY > ADMIN * > SCSI ID'S * > SET ID'S *
NOTE If you are unfamiliar with basic SCSI addressing or LUN addressing, refer to
Appendix B. A web site is also available for more extensive information at:
www.hp.com/isgsupport/optical/index.html
Start with READY in the display.
1. Press
2. Enter the administration password.
3. Press
4. VIEW ID'S displays. Press
5. Press
NOTE In the next step you will choose a new ID. Review this note.
This jukebox, by default, assigns ID 6 to the jukebox controller. When in LUN
mode, the jukebox controller ID uses LUN 0 for itself and assigns the drives to LUN
1 to 2 or 1 to 4 (depending on whether you have two or four drives on in your model
of the jukebox).The result is that there are two types of devices (controller and
drives) at ID 6.
Some host computer systems do not allow you to assign different device types to the
same ID.
Chapter 3
until ADMIN * displays, and then press
NEXT
Instructions for entering this password are in "Entering the Administration
Menu Password" previously in this chapter.
until SCSI ID'S displays, and then press
NEXT
.
ENTER
If you are using basic SCSI addressing (LUN mode OFF):
JKBX ID # LUN # or DRV # ID # LUN # displays. (JKBX ID #
stands for the current ID of the jukebox controller, LUN # is the current logical
unit number, and DRV # ID # is the current ID setting for the displayed drive
number.) When using basic SCSI addressing, the LUN # is always 0.
If you are using LUN addressing (LUN mode ON):
JKBX ID # or DRVs # ID displays. ("#" is the current ID for the jukebox
controller and drives when LUN mode is ON.)
until the setting you wish to change displays, and then press
NEXT
The # (current ID) begins flashing.
ENTER
until SET ID'S displays and then press
NEXT
Operating the Jukebox
Setting the SCSI IDs
.
.
ENTER
.
ENTER
3-17