HP AH164A - StorageWorks 1/8 G2 Tape Autoloader Ultrium 448 Getting Started Manual

HP StorageWorks
1/8 G2 Tape Autoloader

Getting started

© Copyright 2008 Hewlett-Packard Development Company, L.P.
Fourth edition: June 2008
The information in this document is subject to change without
notice.
Printed in the US
www.hp.com
AK377-96003
IMPORTANT:
Shipping Lock: The shipping lock must be removed for the
robotics to work properly. A robot move error is displayed if the
shipping lock is not removed. See Step 5, Removing and storing
the shipping lock.
IMPORTANT:
Both of the Autoloader's side edges must be supported for
the Autoloader to work properly. If you are not mounting the
Autoloader in a rack or installing a desktop conversion kit, ensure
that the feet are properly installed and that all of the feet are
standing on a sturdy, level surface.
IMPORTANT:
Both of the Autoloader's side edges must be supported for
the Autoloader to work properly. If you are not mounting the
Autoloader in a rack, ensure that the feet are properly installed
and that all of the feet are standing on a sturdy, level surface.
WARNING!
The Autoloader weighs 1 1.5 kg (25.4 lb) without media and
13.1 kg (28.9 lb) with media (8 cartridges). When moving the
Autoloader, to reduce the risk of personal injury or damage to
the device:
• Observe local health and safety requirements and guidelines
for manual material handling.
• Remove all tapes to reduce the overall weight of the device.
• Obtain adequate assistance to lift and stabilize the device during
installation or removal.
WARNING!
When placing the Autoloader into a rack, to reduce the risk of
personal injury or damage to equipment:
• Extend the rack's leveling jacks to the floor.
• Ensure that the full weight of the rack rests on the leveling jacks.
• Install stabilizing feet on the rack.
• Extend only one rack component at a time. Racks may become
unstable if more than one component is extended.
Page 1