HP Surestore 160ex - Optical Jukebox User Manual page 54

Table 3-1
Operating the Jukebox
Setting an Operating Configuration
Configuration Choices
Configuration
Name
RECOVERY
ON/OFF
RESTORE
DEFAULTS
CLEAR
ODOMETERS
DUAL PICKER
ON/OFF
STARWARS
ON/OFF
NEW PASSWORD
SCSI LOG
ON/OFF
3-20
Description
Toggles between ON and OFF. If the configuration is
set to ON, the jukebox attempts to recover from errors;
if the configuration is set to OFF, the jukebox
immediately stops moving if an error condition occurs.
The default configuration is RECOVERY ON, and
recovery should remain ON under normal conditions.
Sets all jukebox configurations to default settings.
Used by service personnel only. Sets all jukebox
odometers to zero.
Toggles between ON and OFF. (The default setting is
DUAL PICKER ON, and dual picker mode should
remain ON under normal conditions.) If the
configuration is set to ON, the jukebox runs with dual
picker (disk transport) addressing ON; if the
configuration is set to OFF, the jukebox runs with dual
picker (disk transport) addressing OFF.
Used by service personnel only. Should be set to ON
during normal operation. Toggles between ON and
OFF. The ON configuration enables the vertical
sensors; the OFF configuration disables the vertical
sensors.
Allows you to change the numerical password required
to access the menu choices under the ADMIN * menu
on the jukebox control panel. These choices include
configurations, tests, and information logs. To change
the security code, see "Changing the Administration
Menu Password" in this chapter.
Used by service personnel only. Should be set to OFF
during normal operation. Toggles between ON and
OFF. Tracks internal SCSI states and saves the
information to a log.
Chapter 3