Changing The Current Scsi Ids - HP Surestore 1200ex - Optical Jukebox User Manual

Changing the Current SCSI IDs

READY > ADMIN * > SCSI ID'S * > SET ID'S *
NOTE If you are unfamiliar with basic SCSI addressing or LUN addressing, refer to
Appendix B. A web site is also available for more extensive information at:
www.hp.com/isgsupport/optical/index.html.
Start with READY in the display.
1. Press
2. Enter the administration password.
3. Press
4. VIEW ID'S displays. Press
5. Press
Chapter 3
until ADMIN * displays, and then press
NEXT
Instructions for entering this password are in "Entering the Administration
Menu Password" previously in this chapter.
until SCSI ID'S displays, and then press
NEXT
.
ENTER
BUS 1 * displays. If you want to change the IDs on Bus 1, press
If you want to change the IDs on Bus 2, press
then press .
ENTER
If you are using basic SCSI addressing (LUN mode OFF):
JKBX ID # LUN # or DRV # ID # LUN # displays. (JKBX ID #
stands for the current ID of the jukebox controller, LUN # is the current logical
unit number, and DRV # ID # is the current ID setting for the displayed drive
number.) When using basic SCSI addressing, the LUN # is always 0.
If you are using LUN addressing (LUN mode ON):
JKBX BUS 1 # or DRVs BUS 1 # displays on Bus 1, or DRVs BUS 2 #
displays on Bus 2. ("#" is the current ID for the jukebox controller and drives
when LUN mode is ON.)
until the setting you wish to change displays, and then press
NEXT
The # (current ID) begins flashing.
ENTER
until SET ID'S displays and then press
NEXT
until BUS 2 * displays and
NEXT
Operating the Jukebox
Setting the SCSI IDs
.
.
ENTER
.
ENTER
.
ENTER
3-17