Shipping The Jukebox - HP Surestore 160ex - Optical Jukebox User Manual

CAUTION
CAUTION
NOTE
Setting Up the Jukebox
Moving or Shipping the Jukebox

Shipping the Jukebox

1. Follow your jukebox application software instructions for unmounting and
ejecting disks.
Ensure that there are no disks in the drives.
Failure to eject a disk from the optical drive prior to moving the jukebox could result
in damage to the optical drive mechanism.
Failure to remove all disks from the storage slots in the jukebox could result in
damage to the jukebox.
If you will be manually ejecting disks, refer to "Ejecting an Optical Disk from
the Jukebox" in Chapter 3.
2. Follow your jukebox application's instructions for labeling the disks according
to what you will be doing with the disks (example: archiving, moving them to
another jukebox, etc.)
Turning off the jukebox in the next step could cause data loss if not done correctly.
Do not turn off power to the jukebox until you are sure the SCSI bus is inactive.
Removing power from a SCSI device when the bus is active can result in data loss
and/or indeterminate bus states. Check your host system manuals for information
about checking the SCSI bus status. If your computer is connected to a LAN, be sure
to check with your system administrator before turning off power to the jukebox.
3. Switch jukebox power OFF (see "3" on Figure 1-1).
4. Lift off the left side panel and remove the power cord and the SCSI cable
connections.
5. Loosen the 1/2-inch nut securing the leveler feet and screw the feet up to raise
them away from the floor.
6. Repackage the jukebox in the same way it was received.
Your service representative can provide assistance or advise you on how to best
repackage and ship your jukebox.
1-16 Chapter 1