Encryption Group And Ha Cluster Maintenance; Removing A Member Node From An Encryption Group - Brocade Communications Systems StoreFabric SN6500B Administrator's Manual

6

Encryption group and HA cluster maintenance

Encryption group and HA cluster maintenance

This section describes advanced configuration options that you can use to modify existing
encryption groups and HA clusters, and to recover from problems with one or more member nodes
in the group.
All group-wide configuration commands are executed on the group leader. Commands that clear
group-related states from an individual node are executed on the node. The commands require
Admin or SecurityAdmin permissions.
Displaying encryption group configuration or status information
You can use the - -show
and encryption group status information.
•
•

Removing a member node from an encryption group

This procedure permanently removes a member node from an encryption group, as shown in
Figure
the node are no longer present. To remove a node from a group without disrupting these
relationships, use the cryptocfg
member" on page 307
302
egstatus command to display encryption group configuration information
-
show egstatus cfg Displays encryption group configuration information.
-- - -
show egstatus stat Displays encryption group status information.
-- - -
103. Upon removal, the HA cluster failover capability and target associations pertaining to
for instructions.
replace command. Refer to the section
--
Fabric OS Encryption Administrator's Guide (SKM/ESKM)
"Replacing an HA cluster
53-1002721-01