Brocade Communications Systems StoreFabric SN6500B Administrator's Manual page 251

FIGURE 103
The procedure for removing a node depends on the node's status within an encryption group. HA
cluster membership and Crypto LUN configurations must be cleared before you can permanently
remove a member node from an encryption group. To remove a node from an encryption group,
complete the following steps:
1. Log in to the group leader as Admin or SecurityAdmin.
2. If the node is part of an HA cluster, you must remove it. To do so, complete the following steps:
3. Determine the state of the node. Log in to the member node and enter the cryptocfg
Fabric OS Encryption Administrator's Guide (SKM/ESKM)
53-1002721-01
Removing a node from an encryption group
a. Remove the node from the HA cluster using the cryptocfg
command.
b. Clear all CryptoTarget configurations from the member node using the cryptocfg
container command, or move the container using the cryptocfg
-
command.
groupmember command followed by the node WWN. Provide a slot number if the encryption
-
engine is a blade.
SecurityAdmin:switch> cryptocfg --show -groupmember \
10:00:00:05:1e:41:99:bc
Node Name:
State:
Encryption group and HA cluster maintenance
10:00:00:05:1e:41:99:bc
DEF_NODE_STATE_DISCOVERED
rem haclustermember
-- -
--
move - container
--
--
(current node)
6
delete
show
303