Dell PowerEdge R415 Owner's Manual page 33

Table 1-2. LCD Status Messages (Optional)
Code Text
E1810 Hard drive ##
fault. Review
& clear SEL.
E1812 Hard drive ##
removed. Check
drive.
E1920 iDRAC6 Upgrade
Failed
E1A11 PCI Riser
hardware &
configuration
mismatch.
Reconfigure.
E1A12 PCI Riser not
detected.
Check Riser.
E1A14 SAS cable A
failure. Check
connection.
(continued)
Causes
The specified hard-drive
has experienced a fault.
The specified hard-
drive has been removed
from the system.
The iDRAC6 Express card
is not installed properly or
the card is bad.
PCIe risers are not
configured correctly.
Some invalid
configurations prevent the
system from powering on.
One or both of the PCIe
risers are missing. This
prevents the system from
powering on.
SAS cable A is missing
or bad.
Corrective Actions
See "Troubleshooting a
Hard Drive" on page 163.
Information only.
Reseat the iDRAC6
Express Card. See
Installing an iDRAC6
Express Card. If the
problem persists, see
"Getting Help" on
page 181.
Reinstall the expansion-
card riser. See "Expansion
Card and Expansion-
Card Riser" on page 99.
If the problem persists,
the riser card or system
board is faulty. See
"Getting Help" on
page 181.
Reinstall the missing
riser. See "Expansion
Card and Expansion-
Card Riser" on page 99.
Reseat the cable. If the
problem persists,
replace cable.
If the problem persists,
see "Getting Help" on
page 181.
About Your System
33