Dell PowerEdge R415 Owner's Manual page 134

Figure 3-27. Replacing the System Battery
1 positive side of battery connector
3 negative side of battery connector
5 Locate the battery socket. See "Jumpers and Connectors" on page 173.
CAUTION:
connector while installing or removing a battery.
6 Support the battery connector by firmly holding the positive side of the
connector.
7 Press the battery toward the negative side of the connector and lift it up
out of the securing tab at the negative side of the connector.
8 To install the new system battery, support the battery connector by
pressing down firmly on the positive side of the connector.
9 Hold the battery with the "+" facing the plastic connector on the system
board and slide it under the securing tabs.
10 Press the battery straight down into the connector until it snaps into place.
134
Installing System Components
1
To avoid damage to the battery connector, you must firmly support the
2
3
2 system battery