Sharp AR-FX11 Operation Manual page 21

Using the SPF
6
Press the [START] key (
WXYZ
@.- _
READ-END
• Scanning begins.
• If the line is free, the machine will dial the receiving
machine and begin transmission as soon as the first
page is scanned. (Quick online transmission: page
25)
• If there is a previously stored job or a job is in
progress, or if the line is being used, all pages of the
original are scanned into memory and stored as a
transmission job. (This is called memory
transmission: the destination is automatically called
and the document transmitted after previously stored
jobs are completed.)
If scanning is completed
normally, the following
screen is appears briefly
and then the display
returns to the base
screen.
• To cancel transmission
Note
To cancel transmission while "READING" appears or before the
To cancel a transmission job that is already stored, press the [FAX STATUS] key and cancel the job as
explained on page 26.
• A job number (3 digits) appears in the display with "READ END" when memory transmission is performed. If
you make a note of this number after performing a broadcast transmission, you can use the number to check
the results of the transmission in the transaction report or activity report.
• If the power is turned off or a power failure occurs while an original is being scanned in the SPF, the machine
will stop and an original misfeed will occur. After power is restored, remove the original as explained in
"ORIGINAL MISFEED IN THE SPF" in the "Operation manual (for general information and copier)".
).
READING XX%
No.001 P-XXX
MEMORY AUTO
CONT A4R
AUTO
STANDARD
READ END XX%
No.001 P-XXX
MEMORY AUTO
CONT A4R
AUTO
STANDARD
Using the document glass
6
Press the [START] key (
WXYZ
@.- _
READ-END
Scanning begins.
7
If you have another page to scan,
change pages and then press the
[START] key (
• Repeat this sequence until all pages have been
scanned.
• You can change the resolution and exposure
settings as needed for each page 15.
• If no action is taken for one minute (the [START] key
( ) is not pressed), scanning automatically ends
and the transmission job is stored. (This function can
be disabled in the key operator programs.)
8
After the last page is scanned, press
the [READ-END] key ( ).
@.- _
. #-C READ-END
Open the SPF and remove the original. When the
original is removed or any key operation is performed,
the display returns to the base screen. (The
destination is automatically called and the document
transmitted after any previously stored jobs are
completed.)
key is pressed, press the [C] or [CA] key.
BASIC OPERATIONS
).
READING XX%
No.001 P-XXX
MEMORY AUTO
CONT A4R
AUTO
STANDARD
).
[START]:CONTINUE
[#]:READ-END
MEMORY AUTO
CONT A4R
AUTO
STANDARD
READ END XX%
No.001 P-XXX
MEMORY AUTO
CONT A4R
AUTO
STANDARD
19
2