Selecting Resolution And Exposure Settings - Sharp AR-FX11 Operation Manual

SELECTING RESOLUTION AND EXPOSURE SETTINGS

The resolution and exposure can be adjusted to match the size and darkness of text on the original, or for an original such
as a photograph. To change the settings, follow the steps below after selecting fax mode and placing the original. (Page 13)
1
Press the [RESOLUTION] key.
PAPER COPY AUT
COPY EXPOSURE
SELECT RATIO IMAG
SCAN COLOUR MODE FORM
RESOLUTION ADDRESS
FAX PROGRAM BROADC
The resolution selection
screen will appear.
2
Select the resolution with the [ ] or
[ ] key.
GH
PQR
2-SIDED
COPY
SPECIAL FUNCTION
The selected resolution is
highlighted.
Use this setting for originals with
STANDARD normal-size text (like the text in
this manual).
Use this setting for originals with
small letters or detailed drawings.
FINE
The original will be scanned at
twice the resolution of Standard.
Use this setting for originals with
intricate drawings or diagrams. A
SUPER FINE
higher-quality image will be
produced than with the Fine setting.
Use this setting for originals with
intricate drawings or diagrams.
This setting gives the best image
ULTRA FINE
quality. However, transmission
will take longer than with the
other settings.
Use halftone if your original is a
(FINE/HALF
photograph or has gradations of
TONE) colour (such as a colour original).
(S-FINE/HALF This setting will produce a clearer
TONE) image than "FINE", "SUPER FINE",
(U-FINE/HALF or "ULTRA FINE" used alone.
TONE) When halftone is selected,
transmission will take longer.
To set the exposure next, press the [
and go to step 4.
When the [ ] or [ ] key is pressed, the exposure
display changes from "AUTO" to a 5-step display.
RESOLUTION
STANDARD
FINE
SUPER FINE
AUTO
RESOLUTION
STANDARD
FINE
SUPER FINE
AUTO
] or [ ] key
RESOLUTION
STANDARD
FINE
SUPER FINE
3
Press the [OK] key.
You will return to the base
screen and the selected
BACK OK
resolution will appear in the
resolution display.
GHI
4
Select the desired exposure with the
[ ] or [ ] key.
• To select a light setting for a dark original such as a
newspaper, press the [
toward ( ).
• To select a dark setting for a light original such as
writing in pencil or faint colour text, press the [
to move the setting toward ( ) .
• When the exposure setting reaches the left side or
the right side, pressing the [
the exposure display from the 5-step display to
"AUTO".
5
Press the [OK] key.
You will return to the base
OK
screen and the selected
exposure will appear in the
exposure display.
• The default resolution setting is
Note
"STANDARD" and the default exposure
setting is "AUTO". The default settings for
the resolution and exposure can be
changed in the key operator programs.
(See "RES. CON. SET" on page 100.)
When using the document glass to scan
multiple original pages, the exposure
setting can be changed each time you
change pages. When using the SPF, the
resolution and exposure settings cannot
be changed once scanning has begun.
• Even if you send a fax using a high
resolution setting such as "FINE",
"SUPER FINE", or "ULTRA FINE", some
receiving fax machines may print the fax
at a lower resolution.
• To cancel a resolution or exposure
selection, press the [CA] key.
RESOLUTION
STANDARD
FINE
SUPER FINE
] key to move the setting
] key
] or [ ] key changes
15
1