Sharp AR-FX11 Operation Manual page 79

[PROGRAMMING F-CODE PUBLIC (POLLING
MEMORY) BOXES]
This setting is used to program a box to store
document data for remote transmission when polled by
a machine that supports F-Code communication. Up to
10 boxes can be programmed.
To check the contents of a programmed box, print the
following list: "PRINT - REPORT - SUB ADD SET
LIST" (page 81).
To program an F-code public box, follow steps 1
through 6 on page 74 and then follow the steps below.
7
Select an unused box ("- - - - - -") with
the [ ] or [ ] key.
GH
PQR
2-SIDED
COPY
SPECIAL FUNCTION
8
Press the [OK] key.
BACK OK
GHI
9
Enter a name for the F-code public
box (see "ENTERING CHARACTERS"
on page 82).
26 27 28 29 30
A B C D E
31 32 33 34 35
F G H I J
36 37 38 39 40
K L M N O
Up to 36 characters can be entered for the name. A
box name must be entered.
10
Press the [OK] key.
11
Enter a sub-address (maximum 20
digits) with the numeric keys.
See steps 3 and 4 on page 65.
12
Enter a passcode (maximum 20 digits)
with the numeric keys.
See steps 5 and 6 on page 65.
S.A. MEM POLLING
SBC CO.
— — — — — —
— — — — — —
[OK]:STORE START
S.A. M-POLL NAME
ABC
[EDITING AND DELETING F-CODE MEMORY BOXES]
To edit or delete an F-code box (F-code confidential
box, F-code relay group box, or F-code public box),
follow steps 1 through 6 on page 74 and then follow
the steps below.
Note that an F-code confidential box or F-code public box
cannot be edited or deleted if it contains document data.
7
Select "S.A. CONF. BOX", "S.A.
RELAY GRP", or "S.A. MEM
POLLING" with the [ ] or [ ] key.
GH
PQR
2-SIDED
COPY
SPECIAL FUNCTION
8
Press the [OK] key.
BACK OK
GHI
• If you selected "S.A. CONF. BOX" in step 7, follow
the steps in "EDITING/DELETING AN F-CODE
CONFIDENTIAL BOX" below.
• If you selected "S.A. RELAY GRP" in step 7, follow
the steps in "EDITING AND DELETING F-CODE
RELAY GROUPS" on page 79.
• If you selected "S.A. MEM POLLING" in step 7,
follow the steps in "EDITING/DELETING F-CODE
PUBLIC BOXES" on page 80.
[EDITING/DELETING AN F-CODE CONFIDENTIAL BOX]
9
Select "CHANGE" or "DELETE" with
the [ ] or [ ] key.
GH
PQR
2-SIDED
COPY
SPECIAL FUNCTION
10
Press the [OK] key.
BACK OK
GHI
• If you selected "CHANGE" in step 9, follow the steps
in "Editing an F-code confidential box" on page 78.
• If you selected "DELETE" in step 9, follow the steps
in "Deleting an F-code confidential box" on page 78.
PROGRAMMING
CHANGE/DELETE
S.A. CONF. BOX
S.A. RELAY GRP
S.A. MEM POLLING
S.A. CONF. BOX
CHANGE
DELETE
77
6