Sharp AR-FX11 Operation Manual page 93

Problem
The transmitted image is
distorted.
White or black lines
appear in the transmitted
image.
Transmission does not
take place at the specified
time.
Printing does not take
place after reception.
A received fax prints out
blank.
The received image is
faint.
The received image is
distorted.
A dial tone is not heard
through the speaker.
The machine does not
ring.
Dialling is not possible.
Check
Were line conditions poor
due to thunder or another
reason?
Were the resolution and
exposure settings
suitable?
Is the document glass or
the scanning glass for the
SPF (the long, narrow
glass) dirty?
Is the machine's clock set
to the correct time?
Does an error message
appear regarding adding
paper, replenishing toner,
or a misfeed? (This means
that printing is not
possible.)
Was the wrong side of the
original scanned in the
transmitting machine?
Is the original faint?
Were line conditions poor
due to thunder or another
reason?
Is the volume set to "low"?
Has the ringer volume
been turned off?
Is the telephone line
properly connected?
If an extension phone is
connected to the machine,
has the "EXTENSION TEL"
program been enabled?
Solution
Try the transmission
again.
Check the resolution and
exposure settings.
Clean the document glass
or the scanning glass for
the SPF.
Set the clock to the correct
time.
Restore printing capability
as instructed by the
display message. Printing
will begin.
Check with the operator of
the transmitting machine.
Ask the other party to
re-send the fax using a
suitable exposure setting.
Ask the other party to
send the fax again.
Set the speaker volume to
"middle" or "high".
Set the ringer volume to
"low", "middle", or "high".
Check the connections.
Enable this program.
TROUBLESHOOTING
Page
–
"SELECTING
RESOLUTION AND
EXPOSURE SETTINGS"
on page 15
"CLEANING THE
MACHINE" in the
"Operation manual (for
general information and
copier)"
"DATE & TIME SET" on
page 99
"WHEN AN ALARM
SOUNDS AND A
WARNING MESSAGE IS
DISPLAYED" on page 88
–
–
–
"SPEAKER VOLUME" on
page 97
"SPEAKER VOLUME" on
page 97
"Line connection" on page
4
"EXTENSION TEL" on
page 97
91
7