Ricoh RDC-i500 Operation Manual page 116

Dial-Up Connection (continued)
Error Message
No carrier. Remote system is not
data terminal (MODEM)
No response from remote terminal
Disconnect from remote terminal
Disconnect from PPP server
E-mail/Quick Send
Error Message
Setting error in SMTP server
address
Setting error in POP3 server
address
No Mail setting
114
Cause and Remedy
Dial-up destination has no data terminal (modem)
for communication.
Check telephone number of destination and reset
dial-up account.
Communication may be terminated due to the
situation of the radio frequency, usage
environment, etc. Check that the camera is
located under optimal condition.
There is no response from dial-up destination.
Check telephone number of destination and reset
dial-up account.
Communication may be terminated due to the
situation of the radio frequency, usage
environment, etc. Check that the camera is
located under optimal condition.
Connection has been terminated by dial-up
destination. When you are in the middle of
communicating, check if cable has been removed
or not.
Communication may be terminated due to the
situation of the radio frequency, usage
environment, etc. Check that the camera is
located under optimal condition.
Connection has been terminated by terminal (PPP
server) of dial-up destination. Wait for a while and
establish connection again.
Communication may be terminated due to the
situation of the radio frequency, usage
environment, etc. Check that the camera is
located under optimal condition.
Cause and Remedy
Mail environment setting is incorrect.
Check address of outgoing mail server (SMTP
server) and reset.
Mail environment setting is incorrect.
Check address of incoming mail server (POP
server) and reset.
Mail settings have not been made or are incorrect.
Reset.
Page
P.24
—
P.24
—
—
—
—
—
Page
P.33
P.33
P.33