When The Indicators Provide No Help; The Image Is Not Projected - Epson EMP EMP-9100 Owner's Manual

When the Indicators Provide No Help

Refer to each relevant item if the following situations arise but the indicators provide no help.
· The image is not projected
· No sound
· The image is unclear
· The remote control won't work
· The image is cut up (Large)/Small
· Cannot end
· The image color is bad
· The EMP Link V will not function
· The image is dark

The image is not projected

G Nothing is displayed
Nothing is displayed
page 81
page 86
page 83
page 86
page 84
page 87
page 85
page 87
page 85
G
Is the Lens Cover still in place?
see page 39
G
Has the power been switched off and then on immediately?
The [Power] button will not operate after projection has been
finished (during the cooling down procedure). The [Power] button
will work again after the cooling down process Projection lamp
cooling operations: the operation indicator is illuminated in orange
has been completed.
see page 46
G
Is the Sleep Mode set at ON?
When the sleep mode has been set at [ON], the lamp will be
automatically extinguished if no operations occur and no signals are
input for a period of thirty minutes.
see page 68
G
Did you press the [Power] button?
see page 40
G
Has the brightness of the image been correctly adjusted?
see page 65
G
Is the system in the [A/V Mute] mode?
see page 52
Perform the reset procedure.
see page 69
G
Is the input image completely black?
There are cases where input images will become completely black
owing to screen savers, etc.
G
Are image signals being input?
No message will be displayed if the [Menu] - [Settings] - [No Signal
Display] parameter is set at OFF. Set this to black or blue to display
the message.
Refer to the relevant items when the message is displayed.
(see page 82)
When the Indicators Provide No Help - 81