Indicator Status During Normal Operation; When The Indicators Provide No Help; Check The Problem - Epson EH-TW5100 User Manual

Troubleshooting
Indicators
High Temp Error
(Overheating)
(blue)
(orange)

Indicator status during normal operation

Indicators
Standby condition
(blue)
Warm-up in progress
(blue)
Cool-down in pro‐
gress
Projection in pro‐
gress
(blue)
c
•
Under normal operating conditions, the
•
When the Illumination function is set to Off, all indicators are off under normal projection conditions.
Extended - Operation - Illumination
s

When the Indicators Provide No Help

Check the problem

Check the following table to see if your problem is mentioned, and go to the appropriate page for information
on handling the problem.
Status
The internal temperature is too high.
•
The lamp turns off automatically and projection stops. Wait for
about five minutes. When the fan has stopped, disconnect the
power cord.
•
If the projector is installed next to a wall, make sure there is at
least 20 cm between the wall and the projector's exhaust vent.
•
If the air filter is clogged, clean it. s
•
If turning the power back on does not clear the problem, stop
using the projector and remove the power plug from the elec‐
trical outlet. Contact your local dealer or the nearest Epson repair
center. s
Status
When you press the
control panel, projection starts after a short wait.
Warm-up time is about 30 seconds.
The power-off operation is disabled while the projector is warm‐
ing-up.
All operations are disabled while the projector is cooling-down.
The projector enters standby condition when cool-down is com‐
plete. If for any reason the power cord is disconnected during
cool-down, wait until the lamp has cooled down sufficiently
(about 10 minutes), reconnect the power cord, and then press
the
The projector is operating normally.
and
o
p.51
58
Remedy
Epson Projector Contact List
Remedy
button on the remote control or the
button on the remote control or the control panel.
indicators are off.
m
p.68
: Flashing : Lit : Off