Epson EMP EMP-9100 Owner's Manual page 66

5
Select the parameter value.
Press the [Tracking +, -] button on the projector (lower the [Enter] button left or right on
the remote control unit) to select the parameter value.
Point
· (Enter) is attached to the rear of the sub item names that execute the parameters and
continue onto the lower hierarchies. Press the [Enter] button to set this selection, and then
select the parameter setting again.
· Refer to the list of settings for further information on the function of each setting. (see
page 65)
6
Set all of the other items in the same way.
7
Press the [Menu] button.
The menu will end.
Point
· Press the [ESC] button to return to the previous menu in the hierarchy.
· The items displayed on the image menu will differ in accordance with the projected input
source, and menus other than that belonging to the projected input source cannot be
adjusted.
· Image menus cannot be adjusted when no image signals are being input.
· The last setup screen will be displayed when a menu is ended and then displayed again
(the same status as immediately prior to ending the menu with procedure #7.)
64 - Menu Operations
Language Select [English]
Startup Screen :
ON
Color Setting :
Auto
Comp2Sync Termination
Rear Proj. : ON
Ceiling : ON
Reset Execute
OFF
Manual
Select
: ON OFF
OFF
OFF