Workstation Setup - Xerox WorkCentrePro 123 System Administration Manual

4 UNIX TCP/IP
15.
When you have finished establishing TCP/IP, select [Close] from the [Protocol
Settings] screen.

Workstation Setup

This section explains how to change the workstation OS for Solaris, SunOS, and HP-
UX workstations. Refer to the relevant instructions below.
Solaris – page 51
SunOS – page 52
HP-UX – page 53
Print language/mode/logical printer
A printer name for logical printer should correspond to the print language/mode to be
used for printing, or to the Logical Printer Number which was registered through
CentreWare Internet Services.
PS*
PSASC/PSA*
PSBIN/PSB*
PCL
LP
DUMP/DMP
AUTO/ATO
TIFF/TIF
TIFF%n
PS%n*
*: Option
You can also add output parameters to the above printer name. The parameters are
the same as those for -C option. Insert "_" between the printer name and output
parameter, for example "PS_A4".
NOTE: If specifying a printer name other than above at printing, the print language or
mode specified on the touch screen of the machine is used.
NOTE: When setting print languages/modes from the same workstation to a single
printer, it is recommended to set one kind each. If two or more kinds of languages/
modes are set, the workstation may display the same job number for some query
(lpq).
50
Printer Name
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide
Print Language/Mode/Logical Printer
PostScript
PostScript
PostScript
PCL
Print language which was specified on the touch screen of the
machine.
Dump mode
Auto detection mode
TIFF direct print
TIFF (%n: Logical Printer Number 1 to 10 which were
registered through CentreWare Internet Services.)
PostScript (%n: Logical Printer Number 1 to 10 which were
registered through CentreWare Internet Services.)