Tcp/Ip (Lpd Or Port9100); Information Checklist - Xerox WorkCentrePro 123 System Administration Manual

7 TCP/IP (LPD or Port9100)

This chapter explains how to set up the machine to print from a Windows computer
through LPD or Port9100. The following information is provided.
Information Checklist - page 79
TCP/IP (LPD or Port9100) Environments - page 80
TCP/IP (LPD or Port9100) Installation - page 80
Installation Procedure - page 80
Network Communication Setup - page 81
Workstation Setup - page 82
Test Print - page 83

Information Checklist

Before starting these procedures, make sure that the following items are available or
have been performed.
An existing operational network utilizing TCP/IP is required. These
procedures are not designed to install a network.
Obtain and record the following information:
• IP address
• Gateway address
• Subnet mask
• Host name
Refer to the glossary for additional information about the Gateway
Address and Subnet mask, if needed.
Test the machine to make sure that it is installed fully and functioning
correctly.
Install the print driver.
If problems are encountered during machine setup, refer to the Problem Solving
chapter for assistance.
CAUTION: Do not connect the network cable to the machine until instructed to
do so.
Xerox CopyCentre/WorkCentre/WorkCentre Pro 123/128 System Administration Guide
Item By
Customer
Customer
Customer
Customer
79