Workstation Setup; Test Print - Xerox WorkCentre 4118 System Administration Manual

Workstation Setup

To enable the workstation environment to communicate with the WorkCentre 4118 perform
the following steps:
At the client workstation, install print drivers and map to the printer (see Workstation Setup
1
4-3).
Continue with Test Print on page 2-11.
2

Test Print

To ensure the WorkCentre 4118 has been installed on the network correctly a test print should
be submitted from a client workstation. Perform the following steps:
Ensure the print driver is installed on every workstation that will be sending jobs to the
1
device.
Open a document on a client workstation.
2
Select the WorkCentre 4118 as the printer for sending documents to.
3
Print the document on the device and verify that it prints correctly.
4
Repeat the test for all workstations that will be sending jobs to the device.
5
If the test print fails, refer to the Problem Solving chapter for trouble-shooting procedures.
Xerox WorkCentre 4118 System Administration Guide Page 2-11