Panasonic Digital Palmcoder PalmSight PV-DV100 Operating Instructions Manual page 50

Source
(Playing)
Palmcorder
Before you begin...
• Connect both Palmcorder and VCR to their
power sources
• Connect the Palmcorder to a VCR as
illustratedbelow
• Turn ON both units.
• Set the recording VCR's Input Signal
Selector to LINE.
• Set the Palmcorder POWER Switch to VCR
1
_--A/V Cable [[" TV 1 _)
L
(Supplied)
._ ,+ _____o ,I (To View) _
=--
| --S-Video -VHF Connecting Fjp
/ Cable (not uable tnot _1
I
supplied) supp,ied)
Audioln Videoln
|ToAudioln __ ___
- • II:
eo In 5
To S-Video In
Insert a pre-recorded tape
into the source (playing) Palmcorder
and a blank tape with record tab in
place into the target VCR (Recorder).
Press PLAY on the Palmcorder. When
the tape reaches the point you want to
start dubbing, press PA_AU__E.
Press REC or simultaneouslyRE_C_C
and PLAY (depends on VCR) and then
pause the recorder.
[.,..-.= ,==...1
PAUSEISTILL STOP REW PLAY REC
VCR Buttons
Simultaneously, press PAUSE on
both units to begin the copying
Press STOP on both units when
copying is completed.
(If there is S-Video In)
• Turn the TV ON and select its VCR
channel (either CH3 or CH4)
• Set the VCR/TV Selector on the
recording VCR to VCR
• For technical reasons, dubbing a tape may
reduce its quality
• Press DISPLAY on the Palmcorder remote
control (optional, page 58) to eliminate EVF/LCC
Monitor indications to be recorded on the tape
• If the Time Code is displayed in the EVF or LCD
monitor, this display cannot be reset
50
f--, CAUTION:
| Unauthorized exchanging and/or copying of_
| copyrighted recordings may be copyright
J
_, infringement.