Panasonic Digital Palmcoder PalmSight PV-DV100 Operating Instructions Manual page 48

The original sound can be replaced with
new sound using the built-in Palmcorder
microphone or an external microphone.
External Microphone
with M3 connector
(not supplied)
External
Microphone Jack
Before you begin...
• Connect the external Microphone (if used).
• Turn On the Palmcorder.
• Insert a pre-recorded tape to be dubbed.
The AUDIO-REC setting in CAMERA MENt
mode should be as follows:
12 bit The original sound is recorded on S
(Stereo) 1, and the new sound will b(
recorded on ST (Stereo) 2.
16 bit The original sound is replaced with
the new sound.
• Select 12 bit if you do not want the erigina
sound to be completely replaced during ar
audio dub.
• If you dub over a tape which has both 12
bit and 16 bit audio recordings on it, keep
in mind that the original 16 bit audio
portion will be completely replaced.
A.DUB Button
PLAY Bu_ / PA_E Button
48
A.DUB --
Button
Panasonic _i_ _
,, =©, ©
-_)-_ : i,li
: _,7_h:)%
S=L r_r_
,,o_x ,,*N_
1
2
3
Set POWER to VCR.
• The POWER lamp lights red.
o Be sure POWER is fully turned to
VCR position,
Press PLAY.
Then press PAUSE where you want
dubbing to begin.
Press A.DUB on this unit (for three
seconds) or the remote control
(optional, page 58) to put the
Palmcorder in the Audio Dub mode.
o "A.DUB" flashes in the EVF or the
LCD monitor. EVF/LCD Indication
I \ I / 1
- A-DUB
(Continued on next page.)