Panasonic Digital Palmcoder PalmSight PV-DV100 Operating Instructions Manual page 28

Before you begin...
• Connect the Palmcorder to a power source
(pages 10, 11).
• Insert a cassette with record tab closed
(page 13).
Remove the lens cap and clip it to the hook
TALLY LED
Lights during recording.
POWER
Vision
p,,/Adjustment
i," : _Control
WARNING:
• Do not lift or carry the Palmcorder by the
EVF or the LCD Monitor.
Set POWER to CAMERA.
• The POWER lamp lights red.
• Be sure POWER
EVF
is fully turned to I ,,,sE]
CAMERA position.
Record/Pause mode.
With the Viewfinder Eye Cup up to
your eye, adiust the Vision
Adjustment Control to your eyesight
(page 8),
3
Press RECORD/PAUSE to start
recording.
The Tally LED will be on.
To turn the Tally LED off, see TALLY
LED on page 21.
Press RECORD/PAUSE again to
pause recording.
28
,!
(
i
[:
/
/
t'
• When the Palmcorder is aimed at
excessively bright objects, or bright lights,
a vertical bar may appear in the picture.
This is a normal characteristic of the CCD
pick-up device. Try to avoid this whenever
possible.
- To conserve power
After 5 minutes, the Record/Pause mode will
automatically change to Standbymode.
To resume recording, set POWER to OFF
and then ON again.