Panasonic Digital Palmcoder PalmSight PV-DV100 Operating Instructions Manual page 51

High quality digital-to-digital copyingcan
be accomplished if both Palmcorders
incorporate the digitalin/out IEEE 1394
interface(DV interfacecableis not
supplied).
Source
(Playing)
Palmcorder
__-DV Input/
I_- _-_'-X Output
i ---- (_ ,
_--__/_,.'_ _ Connector
Before you begin... -
• Connect both Palmcorders to their power
sources.
• Connect the two Palmcorders using the DV
interface cable (4-pin to 4-pin).
• Turn both Palmcorders ON.
Insert a pre-recorded tape into the
source (playing) Palmcorder, and set
POWER to VCR.
Insert a blank tape with the record
tab in place into the target (recording)
Palmcorder and set POWER to VCR.
3
Press PLAY on the source
Palmcorder. When the tape reaches
the point you want to start dubbing,
press PAUSE.
/
DV Interface Cable
(Optional)
4
Recording
Palmcorder 5
Hold down REC and press PLAY the
target (recording) Palmcorder or
remote control (optional, page 58).
Press PAUSE to pause the tape at the
starting point of the dub.
Simultaneously, press PAUSE
Buttons on both units to begin the
dubbing.
STOP PLAY PAUSE REC
Button Button Button Button
-
I,_FIFJ
!
PAUSE
Button
0 -) i s_i
REC
Button
_- PLAY
Button
Press STOP on recording
unit, and then press STOP on playing
unit to end dubbing.
• When two Palmcorders are used for
dubbing, it is recommended that the
remote control VCR1 or VCR2 setting
should be used to avoid mis-operation.
• When two Palmcorders are connected
using the DV interface cable (not
supplied), a Video Editing Controller
cannot be used.
• Do not connect both an S-Video Cable or
A/V Cable and a DV Interface Cable.
CAUTION:
nauthorized .exchanging and/or copying of|
opyrighted recordings may be copyright
J
nfringement.
51