Panasonic Digital Palmcoder PalmSight PV-DV100 Operating Instructions Manual page 32

You can control any two Panasonic Digital
Video Camcorder with one Remote control
(Optional, page 58). In order for the remote
to distinguish between the two units, it is
necessary to set one of the Palmcorders to
VCR 2. On the remote, press VCR 1 or
VCR 2 to control the desired Palmcorder.
°:"""'°' rJ
!1 '"" ', ?
For VCR 2 : ' ,_,_ .!7_;_.r..,'_
P ess these _---- ;... ,,o
buttons at Ii_!_ _
[1
same time. '_'_'_' _''_'_
1
2
3
ForVCR1 : AI
'!"
Press these
buttons at
same time.
• When the Palmcorder and remote are
not set to the same mode (VCR1 or
VCR2), "CHECK REMOTE MODE
(REMOTE)" will appear.
REMOTE
Set the POWER to VCR or CAMERA.
• The POWER lamp lights red.
• Be sure POWER is fully turned to
VCR or CAMERA position.
Press MENU to display the VCR or
CAMERA mode menu screen.
Rotate JOG KEY to select
_n the CAMERA mode menu
screen or in the
VCR mode menu screen, then press
JOG KEY to display the CAMERA
SET-UP or VCR PLAY MODE menu
screen.
Rotate JOG KEY to select
and then press JOG KEY to select
VCR 2 on one Palmcorder (pages 21,
23). Leave the other Palmcorder set to
VCR1.
Set the Remote Control (Optional,
page 58) to VCR 1 or VCR 2 to
correspond with the Palmcorder you
wish to control. (See illustration at left.)
• After replacing the Remote Control
Battery, the remote will default to VCR 1.
32
._- '14-
Insert a slender pointed
object, such as the tip of a
ball-point pen into the slot so
that it fits into the hole (as
shown a). Then, while sliding
to the right, pull the Battery
Tray out with your fingernail.
Insert the battery into the
Battery Tray with the (_) mark
facing down.
Do not reverse the polarity.
Insert the Battery Tray.
_Replace battery with •
Panasonic PART NO.
VSBWO004 (CR2025) only.
Use of another battery may
present a risk of tire or
explosion
Caution-battery may
explode if mistreated.
Dispose of used battery
promptly. Keep away from
children. Do not recharge,
disassemble or dispose of
in fire.