Kyocera TASKalfa 3050ci Operation Manual page 472

Symptom
Paper often jams.
Printouts have black
lines.
Printouts are wrinkled
or curled.
Cannot print.
Documents are
printed improperly.
Cannot print with USB
memory.
USB memory not
recognized.
Checkpoints
Is the paper loaded
correctly?
—
Is the paper of the supported
type? Is it in good condition?
Is the paper curled, folded or
wrinkled?
Are there any loose scraps or
jammed paper in the
machine?
Are the slit glass and the
Dual scanning area dirty?
—
Is the paper separator of the
paper feed unit dirty?
Is the paper damp?
—
Is the machine plugged in?
Is the machine powered on?
Are the printer cable and
network cable connected?
Was the machine powered
on before the printer cable
was connected?
Is the print job paused?
Are the application software
settings at the PC set
properly?
Is the USB host blocked?
—
Corrective Actions
Load the paper correctly.
Change the orientation in which the
paper is positioned.
Remove the paper, turn it over, and
reload it.
Replace the paper with new paper.
Remove any jammed paper.
Clean the slit glass and the Dual
scanning area.
Run [Laser Scanner Cleaning].
Clean the paper separator.
Replace the paper with new paper.
Change the orientation in which the
paper is positioned.
Plug the power cord into an AC
outlet.
Turn on the main power switch.
Connect the correct printer cable
and network cable securely.
Power on the machine after
connecting the printer cable.
Resume printing.
Check that the printer driver and
application software settings are
set properly.
Select [Unblock] in the USB host
settings.
Check that the USB memory is
securely plugged into the machine.
12-4
Troubleshooting
Reference
Page
2-29
xli
2-29
2-36
2-29
2-29
12-22
11-16
9-73
11-18
2-27
xli
2-29
2-36
—
3-2
2-3
2-3
8-3
—
9-104
—