Miscellaneous Hardware - Intergraph StudioZ GT RAX Setup Manual

Floppy disk drive LED does not light when system power is on
Reason
The drive's power cable or data cable is not
attached.

Miscellaneous Hardware

"Battery voltage low" message displays
Reason
Lithium battery voltage on the system board
is low.
System loses BIOS configuration information
Reason
Lithium battery voltage on the system board is
low. The system also displays a "battery voltage
low" message during the system boot.
One or more RAID controllers is not recognized
Reason
Message displays, Host adapter at
baseport dc90h is not responding.
RAID controller firmware has been corrupted.
DMA bus timeout message displays
Reason
Failure in DMA bus logic has occurred.
"Invalid configuration information for SLOT XX" message displays
Reason
System is not properly configured to recognize
the new ISA option card.
Solution
Open the base unit and ensure power cable and
data cable are properly attached.
Solution
Replace the battery on the system board.
Solution
Replace the lithium battery on the system
board.
Solution
Remove the RAID controller and reinstall it
into the same slot, ensuring it is completely
connected into the slot.
Call the Customer Response Center.
Solution
Call the Customer Response Center.
Solution
Use BIOS Setup to reserve system resources
for the ISA card. Refer to Chapter 5.
67