Boot; Floppy Check - Intergraph StudioZ GT RAX Setup Manual

Serial Port A/B
These options configure the operation of the serial ports. Select Disable (to disable the selected
port), Enable (to allow user configuration of the selected port), Auto (to enable BIOS or OS
configuration) or OS Controlled (displayed when the operating system controls the configuration).
The default setting is Auto.
Parallel Port
This option configures the operation of the parallel port. Select Disable (to disable the selected
port), Enable (to allow user configuration of the selected port), Auto (to enable BIOS or OS
configuration) or OS Controlled (displayed when the operating system controls the configuration).
The default setting is Auto.
Mode
The parallel port may be set for Output Only (AT), Bi-directional (PS/2), Extended Capabilities
Port (ECP), or Enhanced Parallel Port (EPP). The default setting is Bi-directional.
Floppy Disk Controller
This option configures the operation of the floppy disk controller. Select Disabled (no
configuration), Enabled (allows user configuration), Auto (to enable the BIOS or OS to set the
configuration), or OS Controlled (displayed when the operating system controls the configuration).
The default setting is Enabled.
Base I/O Address
When the floppy disk controller is enabled, this option selects the base I/O address for the
controller. The available settings are Primary or Secondary. The default setting is Primary.

Boot

The Boot Screen allows you to configure the boot configuration. To access this screen, use the
arrow keys to highlight Boot on the BIOS Setup main menu.

Floppy Check

This option verifies the floppy type when the system boots. Disable this option to speed up the
boot process. The default setting is Disabled.
57