Set Supervisor Password; Set User Password; Password On Boot; Exit Screen - Intergraph StudioZ GT RAX Setup Manual

Set Supervisor Password

This selection controls access to the BIOS Setup utility. Press the
Supervisor Password submenu. Type the password, and press the
password and press the
password to nothing (pressing the
WARNING If you forget the Supervisor Password, it cannot be disabled without clearing
the CMOS.

Set User Password

This setting controls access to the BIOS Setup utility. Follow the same procedure used to set the
Supervisor Password.
NOTE When a password is entered, it is saved immediately. All other changes may still be
discarded (see "Exit Screen" in this chapter).

Password on Boot

When this setting is enabled, the system requires a password upon starting up. Either the
Supervisor or User Password may be entered. The default setting is Disabled.

Exit Screen

When you are finished configuring the BIOS, use the arrow keys to highlight the Exit option on the
BIOS Setup main menu. The Exit screen displays.
Choose one of the following exit options. To move between the Exit options, use the up and down
arrow keys ( and ):
Entry
Exit Saving Changes
Exit Discarding Changes
Load Setup Defaults
Discard Changes
Save Changes
To save your changes and restart the computer, choose Exit Saving Changes.
key again. The password may be disabled by setting the new
ENTER
key without first typing a password).
ENTER
Description
Saves the changes you have made, exits the BIOS, and restarts the
system to make these changes take effect.
Leaves the previous BIOS settings intact, exits the BIOS, and
restarts the system.
Returns the BIOS parameters to their original default settings.
Discards any changes you have made, but does not exit the BIOS.
Saves any changes you have made, but does not exit the BIOS.
key to display the
ENTER
key. Retype the
ENTER
59