Changing Virtual Memory Settings - Intergraph StudioZ GT RAX Setup Manual

4. From the Tools menu, click Assign Drive Letter.
NOTE If you select the current drive or an otherwise locked drive, you must restart the
system to complete the drive letter reassignment.
5. Select a new drive letter to assign to the drive from the list. Click OK, and then click Yes to
continue.
6. If necessary, click OK, and then click Yes.
7. Repeat steps 2 through 6 for each drive letter assignment that you want to change.
8. Click Partition, then click Exit. If necessary, restart the system to complete the drive letter
reassignments.

Changing Virtual Memory Settings

If you have more than one hard disk drive, you may need to change size and location of your
virtual memory page file. See Windows NT Help for more information.
Consider the following before changing page file settings:
The size of the page file. If your system is equipped with a large amount of RAM, Setup
might create a page file that is unnecessarily large.
Drive letter reassignments. If you reassigned your drive letters, you may find it necessary to
adjust your page file settings.
To change the size and location of the virtual memory page file:
1. From Start, click Settings, and then click Control Panel.
2. Double-click the System icon.
3. Click the Performance tab and then click Change.
4. Click a drive letter in the list, and then type new values in the Initial Size and Maximum Size
text boxes.
5. Click Set.
6. Repeat steps 4 and 5 for any additional drives in the list.
7. Click Close, then click OK. An alert box displays.
8. Do one of the following:
Click Yes to restart the system with the new settings.
Click No to continue with other tasks and use the new settings the next time you restart
the system.
31