HP StorageWorks 1510i - Modular Smart Array User Manual page 74

8.
In the Management Settings window, enter settings for the management port.
NOTE:
• Port State must be
you must use a Command Line Interface (CLI) command. For more information, see
the Command Line Interface user guide.
• Assign a Host Name to the storage system. (Default: chassis serial number)
• By default, the wizard suggests configuring Logical Port Name MA0 as the primary
management port. HP recommends accepting the default.
• To control the path of management traffic to and from the array controller, and to
add one level of system security, HP recommends assigning a static IP address to the
management port
address, expand the DHCP Setting drop-down box and change the setting to Disabled.
The page expands (shown), showing the currently assigned IP address. Change this to
the address you want to use for management traffic. After changing the IP address, you
may need to re-connect to the SMU, using the newly assigned IP address.
• VLANs are set up on the switch and are used as one method of controlling access to the
storage. If using VLANs, enter the VLAN ID to use (0 = not used).
74
Wizards
Enabled
(default) to use the SMU. To re-enable SMU management,
that is in a different subnet than the data ports
. To assign a static IP