HP StorageWorks 1510i - Modular Smart Array User Manual page 52

2.
Select Target > Enable/Disable Access Control.
3.
Expand the ACL State drop-down box, and enable access control.
4.
The following warning message is displayed:
5.
Confirm that there is no active I/O on the target, and then click OK.
IMPORTANT:
• To prevent loss of access to the storage, ACLs should not be modified if there is an active
session between the initiator and the target. Before enabling ACL for a target, open
your iSCSI initiator software and verify that the target status is inactive or disconnected.
• When access control is
can access the storage targets. (If CHAP authentication is set up, only initiators with
verified CHAP secrets can access the storage.)
• When access control is
immediately blocked
logical drive (Step 6
52
Configure
disabled
(default), all initiators with access to the array controller
enabled
, access to all mapped logical drives of the target is
(Step 2 through Step 3), until ACLs are created for each mapped
through Step 7).