Sample Configuration Status - After Configuring Management And Data Ports - HP StorageWorks 1510i - Modular Smart Array User Manual

4.
Select IP Address > Create Portal.
5.
Enter settings for the portal.
NOTE:
For additional security, do not use commonly-known TCP ports.
6.
When the display refreshes, verify that the newly configured portal is shown in the component list.
7.
As needed for your environment, repeat
this IP address.
8. Repeat Step 1
remaining data ports, such as SA1, SB0, and SB1.
Sample configuration status - after configuring management and data ports
Figure 10 illustrates the current configuration.
The following items are configured:
• Management port MA0 and MB0
• Data ports SA0, SA1, SB0, and SB1
• Each data port is assigned two (2) IP addresses
• Each IP address is assigned two (2) TCP portals
through Step 7 to add additional IP addresses to this data port or to configure the
Step 4 through Step 6 to assign additional TCP ports to
HP Storage Management Utility user guide
37