HP StorageWorks 1510i - Modular Smart Array User Manual page 36

1.
Select Data Port > Add IP Address.
2.
Enter settings for the data port.
NOTE:
• To control the path of storage traffic to and from the array controller and to add one
level of system security, HP recommends assigning an IP Address to the data port that
is in a different LAN segment than the management port. This IP address can not be
changed. To change an IP address assigned to a port, you must add a new IP address
and then delete the unneeded entry. When deleting an IP address, all corresponding
portals and portal group assignments are also deleted.
• By default, the VLAN ID is 0, meaning that traffic flowing from the port to the switch will
be untagged. To assign a VLAN for this port to use, enter its value. VLANs are set up
on the switch, and are used as one method of controlling access to the storage system.
3.
When the display refreshes, expand (+) all components listed for the Data Port and verify that the
newly added IP address is shown in the component list.
36
Configure