Setting Up Target-Specific Initiator-To-Target Chap Authentication - HP StorageWorks 1510i - Modular Smart Array User Manual

1. In the SMU, select Storage System > Canonical Target CHAP Settings.
2. Expand the CHAP State drop-down box and change the setting to Enabled.
NOTE:
If Canonical Target CHAP settings have already been entered, the display is contracted
and protected by a gateway check box. To change existing CHAP settings, clear the Use
Existing CHAP Settings check box. The page expands, allowing access to the settings.
3.
Enter the CHAP Secret in the provided spaces.
4. On the server, open the iSCSI initiator software utility. Navigate through the iSCSI utility and enter
the same canonical CHAP secret assigned in the SMU.
Setting up target-specific initiator-to-target CHAP authentication
Creating a CHAP secret that is unique for each target in the storage system requires two steps:
• Assigning a CHAP secret to each target
• Entering the same CHAP secret in the iSCSI initiator software
54
Configure
(Step 1).
(Step 4).