Figure 12 Sample system configuration—after configuring targets
NOTE:
Figure 12
illustrates the following for Target 1:
•
One logical drive (Logical Drive 1) is mapped to this target.
•
Primary and redundant paths are defined for this target:
• Portal Group "pg1" uses two portals on data port SA0 of the primary Ethernet iSCSI module.
• Portal Group "pg2" uses two portals on data port SB0 of the redundant Ethernet iSCSI module.
Adding authorized initiators
1.
Select Storage System > Add iSCSI Initiator.
HP Storage Management Utility user guide
49