Area measurements
A
19 mm (0.748 inch) or more
B
21.2 mm (0.835 inch) or more
C 4.2 mm (0.165 inch) or more
Overlapping multi-part forms with labels
Same as labels except for the following:
A
the top of
overlapping form
the bottom edge
of overlapping
form
The label on your form should be placed within the shaded area above,
but not on the vertical or horizontal perforation.
Area measurements
A
13
3 mm (0.51
B
62.5 mm (2.46 inches)
C 4.2 mm (0.165 inch)
D
thickness of area where label is attached:
0.53 mm (0.02 inch) or less
E
from perforation to the top of the next overlapping form:
3.3 mm (0.13 inch) or more
F
from perforation to the bottom edge of the glue point area:
17 mm (0.67 inch) or less
G from perforation to the bottom edge of the previous overlapping
form: 13.3 mm (0.52 inch) or less
H
total thickness including glue point dilation:
0.65 mm (0.026 inch) or less
A
A
B
0.12 inch)
(side view)
backing sheet
label
D
perforation
E
C
G
F
the bottom edge of
H
the glue point area
Specifications
A
A-13