Table of Contents
Advertisement
9. Pull out the front paper guide extension completely. Then
slide both right and left edge guides all the way to each
side.
10. Turn on the printer and adjust the page size in your
software, if necessary.
You are now ready to load paper with your cut-sheet feeder as
described in the next section. To remove the cut-sheet feeder,
reverse the steps above.
Loading paper with the cut-sheet feeder
This section describes how to load paper in the cut-sheet
feeders.
For single-sheet multi-part forms, use only the type that are
glued at the top of the forms.
To avoid paper jams, do not allow too many printed sheets to
be stacked on the front paper guide at one time. Remove the
stack when it is half as thick as the paper loading limit marked
on the cut-sheet feeder.
Using Printer Options
6
6-5
Advertisement
Table of Contents
