Gateway 9315 User Manual page 60

9
If it is not already installed, connect the SATA power cable adapter (supplied with the
fixed drive kit) to the 3x2 power supply cable from your power supply.
10
For each drive you install, route one SATA data cable from the server board or add-in
card to the hard drive, with the right-angle end of the SATA data cable connected to
the server board or add-in card SATA connector.
See your server board documentation or add-in card documentation for assistance in
locating the SATA connectors on the board or add-in card.
Important Data cables for drives installed to the right of the air baffle must be
routed through the two cutouts in the top of the air baffle and under
the tab. The data cable for a drive installed to the left of the air baffle
must be routed through the back cutout of the air baffle and under
the tab. You may need to remove the air baffle to route the cables
underneath it. To see how to remove and then install the air baffle,
see "Removing the air baffle" on page 42
on page 44.
www.gateway.com
and "Installing the air baffle"
55