Gateway 9315 User Manual page 62

Important
12
Connect the SATA power cable adapter end(s) to the rear of the SATA drive.
13
Reinstall the bezel, if required, by snapping it into place on the front of the chassis.
14
Follow the instructions in
15
Reconnect all power cords and peripheral device cables, then turn on the server.
Power cables for drives installed to the right side of the air baffle must
be routed beneath the front cutout in the underside of the air baffle.
The power cable for a drive installed to the left of the air baffle does
not need to be routed under the air baffle. You may need to remove
the air baffle to route cables underneath it.
Air baffle
Air baffle cutout
"Closing the server case" on page
www.gateway.com
39.
57