Optional Firmware Upload Settings - Freescale Semiconductor 802.15.4/Zigbee Reference Manual

1.4.1 Optional Firmware Upload Settings

Skip flash erase
o Disabled
o Enabled
Erase production data (get production data from firmware file)
o Disabled
o Enabled
Care must be taken when enabling this option. The user must save a
backup of vital production data (MAC address). The production data can
be manually added to the NVM structure in the NV_Data.c file.
Do not reset after upload
o Disabled
o Enabled
Skip firmware checksum verification
o Disabled
The Embedded Bootloader will report the address of the first data
mismatch found in the current S19 data record. System must be reset if
an error is reported. Check the optional settings and try again.
o Enabled
2)
The UART/USB communication channel is also protected with a protocol checksum.
1-4 Embedded Bootloader Reference Manual, Rev 0.0
The 802.15.4/Application/NVM (except production data section) is erased
(default)
The 802.15.4/Application/NVM is NOT erased
The production data section (with MAC address) in NVM are preserved. All
other NVM values are updated with the values from the S19 record file
(default)
The production data (with MAC address) and all other values in NVM are
erased. All NVM values are updated with the values from the S19 record file
NOTE
The system is automatically reset after upload (default)
The system must be manually reset by user
A checksum verification of the S19 file data record is performed
NOTE
No checksum verification is performed. Flash programming errors cannot be
detected.
2)
(default).
Freescale Semiconductor