Table of Contents
Advertisement
The Embedded Bootloader is now programmed to the PCB as shown in
12. Write NVM production data back by selecting the "PEDebug" menu. Then select "Programming
Options" and "Start Expert Mode Programmer". Select "SS Specify S-record" and locate the
PD_NVM.s19 file built in
written to flash.
13. Remove power and disconnect the BDM cable from PCB. Next, power up the PCB.
The PCB is now ready to upload an application. See
upload an application.
The applications must have the production section in the NVM cleared.
That is, the application image must contain 0xFF's in the production data
section of the NVM.
Freescale Semiconductor
Figure 22 Status Window
Step
10. Select the "PM Program Module" option and production data is
NOTE
Embedded Bootloader Reference Manual, Rev. 0.0
Figure
22.
Chapter 2
for more information about how to
4-9
Advertisement
Table of Contents
