Freescale Semiconductor 802.15.4/Zigbee Reference Manual page 33

5. Make a copy of the NVM sector (both NVM0 and NVM1) with the production data.
Select the "PEDebug" menu, select "Programming Options", and then choose "Start Expert Mode
Programmer". The "Programmer Expert" window appears as shown in
6. In the "Programmer Expert" window, click on "UR Upload Range". The "Start Address" window
appears as shown in
"OK" button. For NVM0 use 0x152F and for NVM1 use 0x172F.
7. In the "End Address" window, which looks very similar to the "Start Address" window, specify the
end address for the NVM section and then click the "OK" button. For NVM0 use 0x155B and for
NVM1 use 0x175B.
Freescale Semiconductor
Figure 18 Programmer Expert Window
Figure 19. Here you specify the start address for the NVM section. Click the
Figure 19 Start Address Window
Embedded Bootloader Reference Manual, Rev. 0.0
Figure 18.
4-7