Preparations; Designating The Type Of Phone Line Being Used (Line Type Setting) (Inch Version Only) - Kyocera KM-C2630D Operation Manual

Section 1 Fax Operation (Names of Parts / Preparations / Features and Functions of this Fax)

Preparations

When using the fax functions of this machine for the first time after purchasing your Fax System, perform the procedures as explained in
"Setting the Type of Phone Line" through "Setting the Current date And Time (Date & Time setting)".
* If your service representative performs these settings during set-up of your Fax System, there is no further need for you to perform these
procedures.
Designating the Type of Phone Line
Being Used (Line Type setting)
(Inch version only)
Set the type of phone line here to correspond to the type of
telephone service that you are using. BE SURE the type of phone
line you select here is correct because, if the setting is incorrect, fax
communication will be impossible.
* Prior to operation, check the message display to make sure that
the touch panel is in the initial mode for fax operation.
(Refer to "What is the "Initial Mode"?" on page 1-11.)
* If you want to cancel the procedure part way through, press the
Reset key. The touch panel will return to the basic copy screen.
1
Press the Default key. The Default Setting screen will
appear.
2
Press the "FAX default" key.
3
Make sure that "Line Type" is highlighted and press the
"Change #" key.
1-6
4
Press either the "Tone Line (DTMF)" key or the "Pulse
Line(10PPS)" key, as appropriate.
5
Press the "Close" key. The message display will return to
the same screen as was displayed in step 3.
6
If you are finished making settings, press the Reset key to
return to the initial mode.